Sullivan County · Kingsport panels

Electrical Panel Replacement & Upgrades in Kingsport, TN

Replacing a worn-out panel or moving a Kingsport house from 100 amps to 200 amps, start to finish by the owner. Call or text (423) 754-4353.

≈ 25 min from Rogersville4.9 from 211 Google reviews
Eaton electrical panel installed by Trent Electrical

Quick answer

Trent Electrical replaces electrical panels and upgrades 100-amp services to 200 amps in Kingsport, including Federal Pacific, Zinsco and fuse box swaps. Owner Ryan Trent, a licensed and insured Tennessee electrician since 2013, does the work himself from his Rogersville base. Call or text (423) 754-4353, 24/7.

Panels I replace in Kingsport homes

Kingsport has a wide spread of house ages. The older ranches and split-levels along Stone Drive, Memorial Boulevard and Lynn Garden were built when 60- and 100-amp service was normal, and many still have the panel they were built with. Out toward Colonial Heights and Indian Springs the houses are newer, but even a 1990s panel can be full once a heat pump, a shop or an EV charger gets added.

The equipment I'm asked about most here is the old stuff: Federal Pacific Stab-Lok panels, Zinsco panels and screw-in fuse boxes. I recommend replacing all three rather than repairing them. Breakers and fuses for that equipment are hard to find and don't give the protection a modern panel does.

Signs your Kingsport panel needs attention

Any of these is a good reason to call or text me for a look:

  • The panel is Federal Pacific, Zinsco or a fuse box
  • Breakers trip often, or won't reset
  • The panel or a breaker is warm, buzzing, or shows scorch marks
  • Lights dim when the HVAC, dryer or microwave kicks on
  • There's no room left for new circuits, so tandem breakers have been crammed in
  • You're adding a heat pump, EV charger, hot tub or shop and the service is 100 amps
  • Rust or water stains inside the panel cover

100A to 200A service upgrades

A lot of Kingsport calls start with "I want to add an EV charger" or "my new heat pump needs a bigger breaker." On a 100-amp house that usually means a service upgrade, not just a new panel. Depending on what's there, a 200-amp upgrade can include the panel, the meter base and the service entrance conductors.

I start with a load calculation so you know whether 200 amps is actually needed. If your existing service can handle the new load, I'll tell you that instead of selling you an upgrade.

What's included in a panel replacement

Every panel job I do in Kingsport covers the full process, not just the box on the wall:

  • A load calculation sized to how you actually use the house
  • The electrical permit for the job
  • The required Tennessee electrical inspection
  • Coordination with AEP / Kingsport Power for the disconnect and reconnect
  • Labeled circuits so you know what every breaker does

Most panel swaps are done in a day

Most straight panel replacements are finished in one day, with power back on the same evening. Service upgrades that change the meter base or service entrance can take longer, depending on utility scheduling and the inspection. I'll tell you what to expect before the work starts.

While the panel is open, it's the easiest time to add a Type 2 whole-home surge protector. It mounts right at the panel, and Kingsport gets its share of summer storms. Ask me about it when we talk through the panel.

Owner-operated, from Rogersville

I'm Ryan Trent. I own Trent Electrical, I've served this area since 2013, and I do every job myself. Trent Electrical is licensed and insured. I'm based in Rogersville, about 25 minutes from Kingsport. You can call or text (423) 754-4353 any time, 24/7, including emergencies. Tell me what's happening and I'll confirm my earliest availability.

Kingsport panel questions

Should I replace a Federal Pacific or Zinsco panel in my Kingsport home?

Yes, I recommend replacing them. Replacement breakers are hard to find, and these panels don't give the protection a modern panel does. I'll look at yours and give you a written quote.

Do I need a 200-amp upgrade to add an EV charger in Kingsport?

Not always. I do a load calculation first. If your current service can carry the charger, you may not need an upgrade. If it can't, I'll explain the options, including a 200-amp service upgrade.

How long does a panel replacement take?

Most panel swaps are done in a day. Upgrades that include a new meter base or service entrance can take longer, depending on utility scheduling and the inspection.

Who handles the permit, inspection and power company?

I do. I pull the electrical permit, schedule the required Tennessee electrical inspection, and coordinate the disconnect and reconnect with AEP / Kingsport Power.

Should I add surge protection when the panel is replaced?

It's a good time to do it. A Type 2 surge protector mounts at the panel, so adding it while the panel is already open is simple.

Licensed & insured · Since 2013

Talk to Ryan about your Kingsport panel

Call or text 24/7 for calls and emergencies. I'll confirm my earliest availability.